ION Adventure Manual Del Usuario página 16

Installing the Suction Mount & Camera into a Vehicle
1. Stop the engine and make sure your car is parked in a safe location.
2. Press the car mount onto the windshield and push the PRESS button to remove
the air between the windshield and car mount.
3. Pull down on the handle of the car mount to tighten
the seal.
4. The camera is designed to mount behind or under the
rear view mirror. The lens of camera should be
positioned at the center of the front windshield. Take
care not to block the driver's visibility.
5. Connect the camera to the DC Power jack in your car
with included USB cable and USB car adapter.
Secure the cable if it is too loose so it will not interfere
with driver motion.
6. Loosen and retighten the screws on the car mount to adjust the camera's
orientation.
Caution When Installing the Camera
•
Installing or operating the product while you are driving may cause an accident.
Stop your car in a safe location to install or operate the product.
•
Dust in the cigarette jack may cause excessive heat or fire. Clean it
periodically.
•
Frequently check whether the camera and mount are installed securely. The
camera or mount may fall due to vibrations and result in personal injury or
damage to the product.
•
The manufacturer is not liable for any product damage or personal injuries that
occur due to accident or carelessness.
www.ioncamera.com
16
EN -