Gps; Sealing Your Camera To Prevent Water Damage - ION Adventure Manual Del Usuario


Auto Rotation is ON by default. You can turn it OFF through the "General
settings" in the iON Application Software, please refer to the Section
"CONNECTING CAMERA TO A COMPUTER.

GPS

The camera has built-in GPS to capture geo-information in photo and video files.
GPS data capture in video/photo files is always on and is not configurable. The first
time you use your camera it will take around 30 to 60 seconds to capture the
satellite signal. After the initial use it will only take about 10 seconds to locate the
satellite signal at power on. Trees, buildings or any high constructions may block
the GPS reception and affect its accuracy. The GPS signal may be completely
blocked indoors or in shielded areas.

SEALING YOUR CAMERA TO PREVENT WATER DAMAGE

The waterproof housing allows you to operate the camera up to 10 meters or 30 feet
under water. You must seal the camera with the basic PODZ (included) or another
PODZ accessory to protect the camera when using it in wet or moist conditions.

The rubber seal on the PODZ forms the waterproof
barrier to protect the camera in wet and underwater
conditions. You must keep this seal clean as a
single strand of hair or grain of sand can cause a
leak into the product.

After every use in salt water, make sure to rinse the
outside of the product and the seal with clean fresh
water and dry thoroughly. Failure to do so will result
in product corrosion and seal decay leading to permanent product damage and
failure.
www.ioncamera.com
24
EN -