Specifications - Sony WAHT-SA2 Manual De Instrucciones

even after checking all the above items,
consult your nearest Sony dealer.
– Flashes green slowly or turns red.
• Confirm the S-AIR IDs of the S-AIR main
unit and surround amplifier.
• Confirm the pairing setting.
• Sound transmission is poor. Move the
surround amplifier so that the S-AIR/
STANDBY indicator turns green.
• Move the system away from other wireless
devices.
• Avoid using any other wireless devices.
– Turns green.
• Check the speaker connections and settings.
• Depending on the source or the settings of the
S-AIR main unit, the effect of the speakers
may be less noticeable.
There is no sound or noise is heard, or
sound skips.
• If you use another S-AIR main unit, place it
more than 8 m (about 25 feet) away from the
other S-AIR main unit you are using.
• Place the S-AIR main unit and surround
amplifier closer together.
• Avoid use of equipment that generates
electromagnetic energy, such as a microwave
oven.
• Place the S-AIR main unit and surround
amplifier away from other wireless devices.
• Change the S-AIR ID settings of the S-AIR
main unit and surround amplifier.
• Turn off the S-AIR main unit and surround
amplifier, then turn them on.
Wireless transmission is not activated.
(The S-AIR/STANDBY indicator flashes
green slowly or turns red.)
• Confirm the S-AIR IDs of the S-AIR main
unit and surround amplifier.
• Confirm the pairing setting.
• Sound transmission is poor. Move the
surround amplifier so that the indicator turns
green.
• Move the system away from other wireless
devices.
• Avoid using any other wireless devices.
Operation
The system does not work normally.
• Disconnect the AC power cord (mains lead)
from the wall outlet (mains), then reconnect
after several minutes.

Specifications

Surround amplifier
(TA-SA200WR)
Amplifier Section
POWER OUTPUT (rated):80 W + 80 W (at
POWER OUTPUT (reference):
Rated impedance
General
Power requirements
Power consumption
Standby power consumption
Dimensions (approx.)
Mass (approx.)
Wireless transceiver
(EZW-RT10/EZW-RT10A)
Communication system
Frequency band
Modulation method
Power requirements
Dimensions (approx.)
Mass (approx.)
3 ohms, 1 kHz, 1 %
THD)
167 W (per channel
at 3 ohms, 1 kHz)
3 - 16 Ω
220 V - 240 V AC,
50/60 Hz
50 W
1.0 W (standby
mode)
0.18 W (turned off)
206 mm × 60 mm ×
256 mm (w/h/d)
with the wireless
transceiver inserted
1.3 kg
S-AIR
Specification
version 1.0
2.4000 GHz -
2.4835 GHz
DSSS
DC 3.3 V, 350 mA
50 mm × 13 mm ×
60 mm (w/h/d)
24 g
11
GB