Technical Specifications - miniland baby digimonitor 2.4 plus Manual De Instrucciones

ENGLISH
Problem
Interference or poor
reception
You cannot charge the
battery in the parent
unit
If the Baby Unit has
lost its link with the
Parent Unit

8. TECHNICAL SPECIFICATIONS

Frequency
Operating Range
Nº of configurable channels
Power (parent unit)
Rechargeable battery for monitor
Power (baby unit)
Operating time with battery fully charged
(parent unit)
LCD Screen size
9. INFORMATION ON DISPOSAL OF BATTERIES AND PRODUCT
· Remember to dispose of the product in an environmentally responsible way, removing the
battery first.
· Do not mix products bearing the symbol of a crossed out bin with normal household waste.
· For proper collection and processing of these products, take them to the collection points
designated by local authorities. You can also contact the store where you purchased the product.
Hereby, Miniland S.A. declares that this "89149 digimonitor 2.4'' plus" is in compliance
with the essential requirements and other relevant provisions of Directive 1999/5/EC.
Possible Cause
The camera or monitor may
be placed too close to many
metal objects
The AC/DC adapter is not
plugged in
The camera and monitor may
be too far apart
The link between both units
has been lost momentarily
The link between bothunits
has been lost
Solution
Move them away from the device
Plug in the adapter
Move the monitor closer to the
camera
Reset the units by disconnecting
them from the electrical power.
Wait about
reconnecting. Allow up to one minute
for the Baby Unit and the Parent Unit
to synchronize.
Pair the camera and monitor again.
See 5.2.9.1.4.
2.4GHz FHSS
250m (straight line and open space)
4
Input: 100-240VAC 50/60Hz Output: 5V
800mA
3.7V 1200 mAh
Input: 100-240 VCA 50/60Hz Output: 5V
800mA
Approximately 8 hours
2.31''
42
15 seconds before