Battery Charging - miniland baby digimonitor 2.4 plus Manual De Instrucciones

ENGLISH
signal from the camera anywhere. Connect the monitor to the adapter plugged into the mains
whenever possible, in order to keep the battery charged.

BATTERY CHARGING:

When the level of battery is low, the charging LED (1)/battery icon (at top-right corner of the LCD)
will turn red and the monitor will start to beep in every 5 seconds.
To charge your monitor:
1. Connect the power adapter to the micro USB socket on the side of the unit (19). For safety
reasons, use only the adapter supplied.
2. Plug the adapter into the mains. The battery pack takes less than 8 hours to charge fully.
When charging:
3. During the charging process and if the unit is ON, the battery icon at the top right corner of the
screen (H) will show that the battery is charging. If instead of this, the unit is OFF, the battery icon
will come up at the middle of screen for a minute before it turns off. While the monitor is charging,
the charging LED (1) will be light in red.
4. When the battery is full charged, the charging LED (1) will turn to solid blue.
5.1.2. BABY UNIT POWER SUPPLY
The camera or baby unit of this baby monitor is designed to be used with the AC/DC adapter
supplied.
1. Locate the connector socket (VII) on the back of the baby unit.
2. Connect the adapter cable to the mini USB socket of the camera (VII). Use only the adapter
supplied.
3. Plug the adapter into the mains.
Warning: Choking hazard – Keep the cord out of the baby's reach. NEVER place a camera
with cables less than 1 meter from the cot. Never use extension cords with AC adapters.
Use only the AC adapters supplied.
5.2. OPERATION
5.2.1. TURNING THE UNITS ON/OFF
5.2.1.1. MONITOR:
Press and hold the Power button (12) to turn the monitor ON. When the monitor is turn on, the
screen will display the welcome screen and the power LED (2) will illuminate green to indicate
the unit is ON.
To turn it OFF press and hold the Power button (12) again.
If for some reason your monitor blocks, press and hold the Power button (12) until the unit turns
off.
5.2.1.2. CAMERA:
To turn the camera on or off, keep the Power button (III) pressed in for two seconds. The ON/link
LED (IX) will go on and off depending on whether you turn the unit on or off.
When you have installed the camera and turned it on, you can see the images and listen to the
sounds captured in your baby's room via the monitor.
30