Swarovski Optik CTS Manual Del Usuario página 11

2. OPERATION
2.1 OPENING THE OBJECTIVE AND OCULAR LENS CAP
The spotting scope is placed in a stay-on case. The caps of the
stay-on case can be pushed to the side (without opening the
press studs) for observing. Alternatively, you can open one of
the press studs, move the caps to the side of the body and then
close the press stud again.
2.2 REMOVAL OF THE STAY-ON CASE
As the stay-on case size is perfectly sized to fit your spotting
scope a slight adherent-effect between the stay-on case and
the extendable spotting scope may occur through time. Remo-
ving the stay-on case can best be achieved by holding the
spotting scope with one hand and pushing the extendable
spotting scope from the eyepiece side forwards out of the
stay-on case.
20
CTS / EN
CTS / DE
2.3 REMOVE THE PROTECTIVE COVER FOR THE BAYONET FROM THE
BAYONET LOCK
To fit the eyepiece, pull out the extendable tube.
To remove the cover, slide the locking mechanism of the
eyepiece downward and turn the protective cover to the left
(anti-clockwise).
2.4 ATTACHMENT OF THE EYEPIECE
• Remove the protective cap for the bayonet from the eyepiece
as described above by screwing it to the left (anti-clockwise).
• The protective cap for the eyepiece is attached to the eye-
piece with a cord. By loosening the screw on the eyepiece with
2
a screwdriver, you can remove the cord with the cap from the
1
eyepiece. Please reinsert the screw.
CTS / EN
CTS / DE
21