Maintenance And Care - Swarovski Optik CTS Manual Del Usuario

2.11 AFTER USE OF THE SPOTTING SCOPE
• Close it until stop.
• Close the lens cap and eyepiece cap from the stay-on case again.
• In order to protect the cover glass in the bayonet fitting, leave the eyepiece mounted
and protect it by putting on its protective cap or close the bayonet fitting with the cover
provided for this purpose.

3. MAINTENANCE AND CARE

3.1 LENS-CLEANING CLOTH
You can clean high sensitive lens surfaces with the enclosed special microfibre cloth. It
is suitable for objective lens, ocular lens and spectacles.
Please keep the cloth clean, as dirt can damage the lens surface. If the cloth becomes
soiled it can be washed in lukewarm soapy water and left to dry. Please only use for
cleaning lens surfaces!
26
CTS / EN
CTS / DE
3.2 CLEANING
On account of the functional principle an extendable spotting scope never can be tight.
When pulling out, air must enter into the instrument. A built-in filter protects the interior
against dirt. When closing the instrument, particular attention should be paid that pos-
sibly no dirt or humidity will remain on the extension tubes.
This assists the cleaning function of the built-in sealing rings. Despite these precautions,
the interior may show, after long year of use, dirt on the optical surface. For such rare
cases, SWAROVSKI OPTIK is providing a cleaning service.
With large temperature changes, the objective may show – when pulling out the spot-
ting scope – some condensation on the inside surface. Normally, such a condensation
should disappear after a short while. If not, it is recommendable to pull out/push in the
spotting scope several times at normal room temperature.
This will make the condensation to disappear. If not, please consider this to be a hint
for a necessary cleaning service as aforementioned.
We have designed all elements and surfaces to require little care. To ensure the long-
lasting optical brilliance of your spotting scope, you should keep the glass surfaces
free of dirt, oil and grease. When cleaning the lenses, first remove larger particles with
an optical lens brush. For the subsequent thorough cleaning we recommend breathing
onto the lens surface to form a coat of condensation and then cleaning it with a soft,
moist cloth.
CTS / EN
CTS / DE
27