Publicidad
Idiomas disponibles
Idiomas disponibles
Programming:
Programming may be done for each day or for a group of days.
In this case instructions are common to several days.
Days: 1 = Monday, 2 = Tuesday, 3 = Wednesday... 7 = Sunday.
1. Select the prog mode using menu, then enter.
1a DT2 and DT2-K: Select the channel
The number of remaining program steps appears for a short time.
2. Select the day(s) using
Validate with enter.
3. ok flashes. Use
-
or
makes it possible to reset the group of days if necessary.
4. Using
+
or -, select the state of the instruction: On, or Off.
Validate with
5. Enter the time of switch-on using
Validate with
6. Enter minutes with
Validate with enter.
Program the other instructions of the group of days by repeating
operations 3 to 6.
The day or the group of days may be modified at the during step 3 by pressing
+
-
or
.
,
At the end of programming return to auto mode using the
DT2 and DT2-K: To set the program of the other channel, return to prog new
mode and proceed according to steps 1a. to 6.
In this mode it is also possible to add an instruction to the program set up.
Proceed as described above.
On
0
+
or -.
enter
to validate the group.
enter
enter
+
or -.
prog new
prog
new
ok
6
12
18
(C1
or C2) using
+
or -.
4
24
+
or
-,
then enter.
menu
button.
Publicidad
