Beper P203TER100 Manual De Instrucciones página 13

Wall Mounted Fan Heater Use instructions
and disconnect it from the wall socket.
When the appliance is working, avoid opening and closing doors or
windows, to ensure quick and even distribution of heat throughout
the room.
The remote control provided contains a pre-installed lithium battery.
Keep the remote control and its battery away from children.
Warning: if swallowed, the battery can cause internal burns,
perforation of soft tissues, and lead to potentially lethal inju-
ries. Severe burns can occur within 2 hours from swallowing.
Seek immediate medical attention if ingestion is suspected.
Do not let children replace the battery without adult supervision.
Do not expose battery to high temperature. Remove it from remote
control if it is not used for long time.
Do not dispose of the exhausted battery in regular waste; do not
throw it in fire or attempt to burn it. Follow applicable local regulations
for the correct disposal of batteries.
Warning: some parts of the appliance may become very hot
during operation, it is necessary to exercise extreme care in
the presence of children and vulnerable persons.
Product description Fig. A
1. LED display
2. Swing wing and fan hole
3. ON/OFF switch (at the back)
4. Operation switch (at the back)
Wall mounting Fig.B
To avoid any possible damage to persons and/or objects, wall mounting of the appliance should be done by
professionally trained personnel.
Warning: make sure there are no electrical cables or pipes at the points selected for the anchor ho-
les. Make sure that the appliance is securely fixed and mounted on to the wall.
Note: do not remove the plug and do not modify the power cord in any way; if performed, these opera-
tions lead to the forfeiture of the warranty terms.
Make two holes at approx. 2 meters from the floor, and leave at least 30 cm from the corners and from the ceiling.
Make sure the holes are wide enough for the screws to fit, but not too wide to prevent them from performing their
function. Fasten 2 screws and anchors to the wall, the head of the screws must protrude by about 10mm, so that
they can support the product; hold the appliance tightly until the screws are securely fastened.
Power on
After installing the appliance, and connecting it to the wall socket, place the ON/OFF switch (at the back) on "I"
position; the appliance will emit a short beep, and the LED display will turn on, showing room temperature and
blinking for about 3 seconds.
13
EN