Beper P203TER100 Manual De Instrucciones página 14

Wall Mounted Fan Heater Use instructions
Remove the protective film from the battery inside the remote control to activate it.
Date and time setting
On remote control, press LOCK key, the display will show time 00:00 and the number "1".
To set the time, press SET key once, on the display the corresponding numbers will blink; at this point, with +
and -, select the hour (from 00 to 12).
To set the minutes, press SET key again, on the display the corresponding numbers will blink; using + and -,
select the minutes (from 00 to 59).
To set the date, after programming hour and minutes, press the SET key again: on the display, the number "1"
will blink; using + and – select the correct day of the week (1=Monday; 2=Tuesday; 3=Wednesday; 4=Thursday;
5=Friday; 6=Saturday; 7=Sunday).
Note: after pressing the SET key, the selected indicator will blink for about 5 seconds; if no setting is
made within this time, the display will stop blinking and the appliance will return in stand by mode (press
SET key again to restart setting operations).
Operation
Switch the appliance on by pressing the ON/OFF key on the remote control; the appliance starts working in fan
mode (room temperature air is blown out), and on the display the icon lights up.
By pressing the MODE key, the eco heating mode will be activated, and on the display the icon will light up.
Press the MODE key again, the comfort heating mode will be activated, and display will show the icon.
By pressing the MODE key one last time, heating function is switched off, and the appliance goes back to fan
mode (blowing air at room temperature), and display shows the indicator.
Note: pressing the operation switch at the back of the appliance, the appliance will automatically activa-
te the comfort heating mode, and display will show and icons.
The appliance is equipped with a protection system that switches off the appliance in case of overheating (e.g.
in case fan holes are clogged). In case the appliance suddenly shuts off, unplug it from wall socket, let it cool
down for at least 30 seconds and check its state; then reconnect it to the plug, and turn it on again. If this problem
persists, contact your local distributor for assistance.
Setting of 24H timer
With the appliance on and working, press 24H key on the remote control to set the timer for daily shut off.
Timer can be set from 01 to 24 hours, in 1-hour intervals.
Press 24H key until the display show the desired setting; display will also show D icon.
Note: with 00 selection, timer is not activated.
Temperature setting
With the appliance on and working, set the temperature by pressing + or – keys on the remote control.
Temperature can be set from 10°C to 49°C; display shows icon.
When detected room temperature is 2 or less degrees lower than set temperature, econ heating mode is auto-
matically activated (1000W).
When detected room temperature is 4 or more degrees lower then set temperature, comfort heating mode is
automatically activated (2000W).
If detected room temperature is 1°C (or less) lower than set temperature, heating mode is deactivated, and the
appliance blows air at room temperature.
Week timer setting
With the appliance on and working, press the W+timer key on the remote control, and select the desired program
with the + and – keys.
The appliance ha 6 different programs available.
P1 to P5 are pre-set programs, based on the following table:
14