5.4
Connecting the DMX connection cable
How to proceed:
G
1. Remove the protection cap from the unit.
2. Fit the connector of the connection cable and secure with the two screws (max. 2.0 Nm).
– Ensure that the rubber seal is clean and fits exactly.
– Replace the rubber seal if damaged.
5.5
Connect the units to the power supply distributor
• Do not connect any InScenio controllers or portable multiple sockets to the unit.
How to proceed:
1. Choose a suitable socket (see fig. above) and insert the unit power plug into the socket.
– Check that your OASE unit may be connected to this socket. For this purpose, consult the instructions of
use of the unit you wish to connect.
– The following applies: Units powered via a transformer may not be connected to a socket with dimmer
function.
H
2. Fit the protection hood.
6
Commissioning/start-up
The unit is operated via the "Oase FM-Master" app on your smartphone or tablet. Proceed as follows for
starting up:
• Install the "OASE-FM-Master" app. (→ Installing the APP)
• Connect the FM-Master WLAN to the power supply.
• Establish the WLAN connection.
The smartphone/tablet can connect to the FM-Master WLAN in two ways:
• Smartphone/tablet and FM-Master WLAN are connected via an available WLAN router. (→ Establishing a
connection via WLAN router)
• Smartphone/tablet and FM-Master WLAN are directly connected via WLAN. (→ Establishing a direct WLAN
connection)
N O T E
6.1
The LED on the FM-Master WLAN indicates the current operating status. (→ Operating status display
)
1 Socket 1, switchable (max. 10 A / 2000 W)
2 Socket 2, switchable (max. 10 A / 2000 W)
3 Socket 3, switchable (max. 10 A / 2000 W)
4 Socket 4, switchable and dimmable (40 W ... 320 W)
Note: Ensure that the total output of 16 A / 3600 W is not exceeded!
- EN -
35