Commissioning; Tips And Recommendations For Installation - SOMFY Movelite WireFree RTS Guia

2.3. COMMISSIONING

2.3.1. Pre-programming the RTS remote control (Fig 5)
1) Connect battery pack to the motor, refer to 2.2.1.
2) Press the Open and Close buttons on the RTS remote control at the same time: The motorised product
moves briefly, and the RTS remote control is pre-programmed in the motor.
2.3.2. Setting the end limits
At the first command Open or Close, the motorised product make a first run to record the hard stop position.
If need to adjust end limits, refer 2.4.2
2.3.3. Checking the direction of rotation (Fig6)
1) Press the Open button on the RTS remote control:
a) If the motorised product opens (a), the direction of rotation is correct.
b) If the motorised product closes (b), the direction of rotation is incorrect: Move onto the next step.
2) Press the my button on the RTS remote control until the motorised product moves: The direction of
rotation has been modified.
3) Press the Open button on the RTS remote control to check the direction of rotation.
If need to change the direction of rotation, refer 3.4.4
2.3.4. Recording the RTS control point (Fig 7)
Press the PROG button on the back of the remote control until the motorised product moves. The remote
control address is permanently recorded.
2.3.5. Adjusting the Touch motion sensitivity (Fig 8)
and

Move the motrised product away from the end limits.
e it
1) Press the Open and Close buttons of the RTS remote control simultaneously until the motorised product
moves.
LED is green the motor enter touch motion sensitivity setting mode
2) Press the Open and Close buttons simultaneously until the motorised product moves to switch from high
sensitivity, to low sensitivity, to no touch motion, and back to high sensitivity.The LED is on
e
- orange LED fast blink for high sensitivity
- orange LED slow blink for low sensitivity
- orange LED on for no touch motion
3) Press the my button until the motorised product moves to confirm the setting.

2.4. TIPS AND RECOMMENDATIONS FOR INSTALLATION

2.4.1. Questions about the Movelite
Observations
The motorised product
is
does not operate.
.
Copyright © 2018 SOMFY ACTIVITÉS SA, Société Anonyme. All rights reserved
rved
WireFree?
TM
Possible causes
The battery pack is weak.
The remote control battery is weak.
The remote control is not
compatible.
The remote control used has not been
programmed into the motor.
Solutions
Check whether the battery pack is
weak and charge it.
Check whether the battery is weak and
replace it if necessary.
Check for compatibility and replace the
remote control if necessary.
Use a programmed remote control or
program this remote control.
.
EN
5