3.4.2. Deleting the favourite position (my) (Fig 17)
1) Press my: the motorised product starts to move, and stops in the favourite position (my).
2) Press my again until the motorised product moves: the favourite position (my) is deleted.
3.4.3. Adding/Deleting Somfy control points (Fig 18)
1) Find an RTS remote control programmed in the motor.
Press & hold the RTS programmed remote control (A) PROG button or the button on the bottom of the
motor until the motorised product moves, the motor is in programming mode.
2) Quickly press the RTS remote control (B) PROG button to add or delete, the motorised product moves &
the RTS remote control (B) is programmed or deleted from the motor.
3.4.4. Modifying the motor rotation direction (Fig 19)
Move the motorised product away from the end limits.
1) Press the Open and Close buttons of the RTS remote control simultaneously until the motorised product
moves.
the LED is green or green blink
2) Press the my button until the motorised product moves to reverse the rotation direction.
3.4.5. Low Battery Charge (Indicator)
1) Motor will emit one audiable "beep" ( one «beep» before motor start to run and another «beep» after
the operation )follow operation of Drapery motor.
are
Charge battery as per instructions 2.2.2 on previous page (or see Charging the Battery Pack).
2) motor will emit one «beep» and LED red fast blink when no battery.
otor
Charge the battery as per instruction 2.2.2
3.5. TIPS AND RECOMMENDATIONS FOR USE
3.5.1. Questions about the Movelite
urite
Observations
The motorised product
uct
does not operate.
If the motorised product still does not work, contact a motorisation and home automation professional.
3.5.2. Replacing a lost or broken Somfy remote control
To replace a lost or broken remote control, contact a Somfy motorisation and home automation professional.
4. TECHNICAL DATA
Battery pack nominal voltage
Battery pack continuous working current
Radio frequency
Operating temperature
Index protection rating
Safety level
Battery charging temperature
particulars for identification of the drive, name and address of the person(s) authorised to compile the technical
file and empowered to draw up the declaration including place and date of issue is available at www.somfy.
com/ce.
.
Copyright © 2018 SOMFY ACTIVITÉS SA, Société Anonyme. All rights reserved
rved
WireFree?
TM
Possible causes
The remote control battery is weak.
The battery pack is weak.
Somfy hereby declares that the drive covered by these instructions and used as intended
according to these instructions, is in compliance with the essential requirements of Directives
2006/42/EC, and 2014/53/EU.
A declaration of conformity detailing the standards and specifications used and stating all
Solutions
Check whether the battery is weak and
replace it if necessary.
Check whether the battery pack is
weak and charge it.
14,8V
2A
433.42 MHz
0°C to + 60°C
IP 30
Class III
0°C to + 40°C
.
EN
7