General Instructions; Technical Characteristics - Ariston SG 200 Manual De Instrucciones

GB
Introduction
This operating manual is an integral and essential part of the product. The user should
keep it in a safe place and it must always accompany the boiler, even if the appliance is
sold to another owner or user and/or moved to another installation site.
Please read this operating manual carefully; the instructions and warnings contained
within it provide important information for the safe installation, operation and maintenance
of the new appliance.

General instructions

This appliance is used to produce hot water for domestic use, at a temperature which is
lower than the boiling point.
It should be connected to the distribution mains supply for domestic hot water in accordance
with the performance levels and power rating of the appliance.
It is strictly prohibited to use the appliance for any purpose other than those specified.
The manufacturer shall not be held responsible for any direct or indirect damage caused
by improper and incorrect use of the appliance, non-adherence to established technical
procedures, or by the failure to comply with the instructions given in this manual.
Installation, maintenance and all other work must be performed by qualified personnel
in full compliance with all applicable legal regulations and with the instructions provided
by the manufacturing company.
Incorrect installation can harm persons, animals and possessions; the manufacturing
company shall not be held responsible for any damage caused as a result.
Keep all packaging material (clips, plastic bags, polystyrene foam, etc.) out of reach of
children as it may present a potential hazard.
It is strictly prohibited for children or inexperienced people to use the appliance.
It is strictly prohibited to touch the appliance while barefoot or with wet hands or feet.
All repairs should be performed exclusively by qualified staff, using only original spare
parts. Failure to comply with the above instructions could compromise safety and will
exempt the manufacturer from all liability.
The temperature of the hot water is adjusted by an operating thermostat which acts as
a resettable safety device so as to avoid dangerous increases in the temperature level.
The electrical connection of the appliance should be performed in accordance with the
instructions provided in the relevant paragraph.
The pressure safety device, when supplied with the appliance, should not be tampered
with or replaced.
No flammable items should be left in the vicinity of the appliance.
IMPORTANT:
This appliance should not be operated by individuals (including children) with reduced
physical, sensory or mental capacities, or by inexperienced or unskilled individuals; these
people should at least be supervised and instructed by responsible individuals when
operating the appliance, to ensure their own safety.
Children must be supervised at all times, to ensure that they are not playing with
the appliance.
Identification notes
The appliance identification plate listing all the relevant data is located on the lower part
of the product, near the protection cap.

Technical characteristics

The appliance consists of:
- a tank, the inside of which is protected by a layer of vitreous enamel;
- an anode protection system;
- an external coating of powder-painted sheet metal;
10