Electrical Safety - MAG TOOLS MPF980381 Manual De Instrucciones

dust to get into your mouth, eyes, or lay on the skin may promote absorption of harmful chemicals.
• Use of this tool can generate and/or disperse dust, which may cause serious and permanent respiratory
or other injury. Always use NIOSH/OSHA suitable approved respiratory protection appropriate for the dust
exposure and suitable extraction systems. Direct particles away from face and body.
• Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool
or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users.
• This product may contain one or more chemicals known to the State of California to cause cancer and
birth defects or other reproductive harm. Wash hands thoroughly after handling.
• Do not let children come in contact with this tool. Supervision is required when inexperienced operators
use this tool.
• Do not modify this tool. Modifi cations can reduce the effectiveness of safety measures and increase the
risks to the operator.
• Do not discard the safety instructions; give them to the operator.
• Do not use the tool if it has been damaged.
• Be aware that the failure of the workpiece or accessories, or even of the tool itself, can generate high-velo-
city projectiles.
• This product is not intended for use by persons (including children) suffering from diminished physical,
sensory or mental abilities; lack of experience, knowledge or skills unless they are supervised by person
responsible for their safety. Children should never be left alone with this product. This tool and its acces-
sories must be used in compliance with these instructions. Using it for any other purpose may cause a risk
of danger for people and the environment.
• Only qualifi ed and trained operators should install, adjust or use the tool.
• For overhead work, wear a safety helmet.
• Direct the exhaust so as to minimize disturbance of dust in a dust-fi lled environment. Do not direct
exhaust air towards hands.
• Where dust or fumes are created, the priority shall be to control them at the point of emission.
• All integral features or accessories for the collection, extraction or suppression of airborne dust or fumes
should be correctly used and maintained in accordance with the manufacturer's instructions.
• Always operate, inspect and maintain this tool in accordance with American National Standards Institute
Safety Code for Portable Air Tools (ANSI B186.1) and any other applicable safety codes and regulations.
• Do not free run tool with socket installed on tool.
• Do not splash or immerse in water or other liquids.
• Do not incinerate even if severely damaged or completely worn out. The battery can explode in a fi re. Toxic
fumes and materials are created when lithium ion batteries are burned.
• If battery contents come into contact with the skin, immediately wash area with mild soap and water. If
battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. If
medical attention is needed, the battery electrolyte is composed of liquid organic carbonates and lithium
salts.
• Contents of opened battery may cause respiratory irritation. Provide fresh air. If symptoms persist, seek
medical attention.
• Burn hazard. Battery liquid may be fl ammable if exposed to spark or fl ame.
• Fire hazard. Never attempt to open the battery pack for any reason. If the battery pack case is cracked or
damaged, do not insert into the charger. Do not crush, drop or damage the battery pack. Do not use a bat-
tery pack or charger that has received a sharp blow, been dropped, run over or damaged in any way (e.g.,
pierced with a nail, hit with a hammer, stepped on).
• Please note that changes or modifi cations not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
WARNING: Never modify the unit or any part of it. Damage or personal injury could result.
CAUTION: Do not stare into LED light. Serious eye injury could result.

3) ELECTRICAL SAFETY

• Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any adapter plugs
with earthed (grounded) power tools. Unmodifi ed plugs and matching outlets will reduce risk of electric
shock.
800.MACTOOLS
5