MAG TOOLS MPF980381 Manual De Instrucciones página 9

LED light is shipped in sleep mode, charging activates light function. (see charging section below)
Installation and Removal of LED Light
Removal: To remove LED light accessory from tool, rotate the LED light accessory counter clockwise, the LED
light will make a 'snap' noise as it rotates. At the top of the nose cone, the unlock symbol will line up with the
hash mark when fully unlocked. Pull the LED light accessory straight away from the tool to remove. Charging
port is located on the back side of LED light accessory (see charging section below).
Install: To install LED light accessory onto tool, line up the hash mark on top of the nose cone with the unlock
symbol. Place LED light accessory onto nose cone toward back of tool until it stops. THEN rotate clockwise, the
LED light accessory will make a 'snap' noise as it rotates and locks in place. The hash mark on top of the nose
cone will now be lined up with the lock symbol.
Charging: To charge the unit, connect the USB charging cable into
the charging port (A, Fig. 2) on the unit and then plug it in to an
appropriate USB port. The AC adaptor can also be used to charge
the unit via a standard electrical outlet.
Longest life and best performance can be obtained if the battery
pack is charged when the air temperature is between 65 °F and 75
°F (18° – 24 °C). DO NOT charge the battery pack in an air tempe-
rature below +40 °F (+4.5 °C), or above +105 °F (+40.5 °C). This is
important and will prevent serious damage to the battery pack.
NOTE: While the unit is charging, the LED Light will blink conti-
nuously indicating that the charging process has started. The
completion of charge will be indicated by the LED light remaining
ON continuously in a dimmed state. The battery pack is fully char-
ged and may be used at this time or left in the charger. NOTE: To
ensure maximum performance and life of lithium-ion battery packs,
charge the battery pack fully before fi rst use. The LED Light will fully
recharge in 4 hours or less.
CAUTION: Do not stare into LED light. Serious eye injury could result.
There are two LED lights located around the square drive. The LED lights are activated when the trigger switch
is depressed.
- On the North American Version, when the trigger is released, the LED light will stay illuminated for up to 5
seconds. If the trigger switch remains depressed, the LED light will remain on.
- On the United Kingdom version, the LED lights will turn off after being illuminated for 20 seconds.
NOTE: The LED Lights are for lighting the immediate work surface and are not intended to be used as a fl ashlight.
ADAPTOR STATUS INDICATOR
Fig. 3
SERVICE
• Tool service must be performed by qualifi ed repair personnel, using only Mac Tools authorized, identical
replacement parts. Use only lubricants recommended by Mac Tools.
800.MACTOOLS
State of charge
_ _ _ _
charging
________
fully charged
Fig. 2
A
9