Safety Warnings Specific For Wire Brushing Operations; Additional Safety Information - Black and Decker G950 Manual De Instrucciones

Ocultar thumbs Ver también para G950:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Safety Warnings Specific for Wire
Brushing Operations
a ) Be aware that wire bristles are
thrown by the brush even during
ordinary operation. Do not
overstress the wires by applying
excessive load to the brush. The
wire bristles can easily penetrate light
clothing and/or skin.
b ) If the use of a guard is
recommended for wire brushing,
do not allow any interference of the
wire wheel or brush with the guard.
Wire wheel or brush may expand in
diameter due to work and centrifugal
forces.
c ) Safety goggles or safety glasses
with side shields and a full face
shield compliant with ANSI Z87.1
MUST be worn by the operator and
others that are within 50' (15.2 m)
of the use of this product.

Additional Safety Information

WARNING:
: ALWAYS use safety
glasses. Everyday eyeglasses are NOT
safety glasses. Also use face or dust mask
if cutting operation is dusty. ALWAYS
WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/
CSA Z94.3),
• ANSI S12.6 (S3.19) hearing
protection,
• NIOSH/OSHA/MSHA
respiratory protection.
WARNING:Some dust created by power
sanding, sawing, grinding, drilling, and
other construction activities contains
chemicals known to the State of California
to cause cancer, birth defects or other
reproductive harm. Some examples of
these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks
and cement and other masonry
products, and
• arsenic and chromium from
chemically-treated lumber.
Your risk from these exposures varies,
depending on how often you do this type
of work. To reduce your exposure to these
chemicals: work in a well ventilated area,
and work with approved safety equipment,
such as those dust masks that are specially
designed to filter out microscopic particles.
• Avoid prolonged contact with
dust from power sanding, sawing,
grinding, drilling, and other
construction activities. Wear
protective clothing and wash exposed
areas with soap and water. Allowing
dust to get into your mouth, eyes, or lay
on the skin may promote absorption of
harmful chemicals.
WARNING:Use of this tool can generate
and/or disperse dust, which may cause
serious and permanent respiratory or other
injury. Always use NIOSH/OSHA approved
respiratory protection appropriate for the
dust exposure. Direct particles away from
face and body.
WARNING: Always wear proper
personal hearing protection that
conforms to ANSI S12.6 (S3.19) during
use. Under some conditions and duration
of use, noise from this product may
contribute to hearing loss.
CAUTION: When not in use, place tool
on its side on a stable surface where it
will not cause a tripping or falling
hazard. Some tools with large battery
packs will stand upright on the battery
pack but may be easily knocked over.
• Air vents often cover moving parts
and should be avoided. Loose clothes,
jewelry or long hair can be caught in
moving parts.
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
or DC ...... direct current
...................... Class I Construction
(grounded)
.../min .............. per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................ watts
or AC ........... alternating current
• When using an extension cord, be
sure to use one heavy enough to carry
the current your product will draw. An
undersized cord will cause a drop in
6
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n o ....................... no load speed
n ......................... rated speed
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection

Publicidad

Tabla de contenido
loading

Tabla de contenido