Introduction; Consulting The Use & Maintenance Manual; Symbols And Qualifications Of The Operators; Compliance Certificate - CAMPAGNOLA POWER 12 Manual De Uso Y Mantenimiento

1

- IntroductIon

1.1 consulting the use & maintenance manual
Before working on the equipment, carefully read and understand this use & maintenance manual in order to safeguard the op-
erator and to avoid damaging the machine. These instructions describe how to operate the equipment safely, economically and
in compliance with the current safety regulations. Following these instructions helps avoid dangerous situations, reduces repair
costs and down-time and extends the service life of the machine. This manual is to be kept legible and in good condition. The
operating and maintenance staff must have it at hand, so that it can be read whenever needed.
1.2 Symbols and qualifications of the operators
All the operations described in this manual must be performed by qualified personnel and in compliance with the manufacturer's
manual. Each procedure described herein is accompanied by an icon which indicates the necessary operator's qualification. The
indications to identify the personnel qualifications are given below.
operator
Personnel who can install, operate, adjust, clean, repair, transport the equipment and carry out its ordinary maintenance.
Qualified mechanic
Personnel capable of installing, servicing and/or repairing the equipment as directed in this manual.
He cannot carry out interventions on the electric system.
Qualified electrician
Personnel capable of using the machine in normal work conditions even when all safety systems are off due to maintenance
and/or repair operations.
He cannot carry out interventions on the mechanical system.
authorIzed ServIce PoIntS
Centres, indicated by the sales staff of CAMPAGNOLA S.r.l., authorized to repair the products.
WarnInG!
Precautions to be taken in order to safeguard the operators and bystanders in the work area.
ImPortant!
Precautions to be taken in order to avoid problems with the equipment and to operate it in compliance with the current
safety regulations.
1.3 compliance certificate
All the products to be marketed in the European Union (EU) must comply with the European Council Directive 2006/42/CE fully.
The compliance certificate is supplied by the manufacturer with the Use & Maintenance Manual.
1.4 receiving the product
When receiving the product, make sure:
• the product has not been damaged during transport;
• the product supplied is the same as that ordered. Check that all parts have been delivered (refer to "Product Description",
"Specifications" chapter). If problems arise, contact the manufacturer's service department quoting all details indicated on
the nameplate (refer to "Product Description", "Specifications" chapter).
15 - 68