Manual Choke Start - Firman W03383 El Manual Del Propietario

Ocultar thumbs Ver también para W03383:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4. Turn the
position.
5. Flip the
Starter
and arm toward engine faster than you can let go which could cause broken
the battery power restore switch for about
3 seconds and then release.
Keep choke lever in "CHOKE" position for only 1 pull
of the recoil starter. After first pull, move choke lever
to the "RUN" position for up to the next 3 pulls of
the recoil starter. Too much choke leads to
sparkplug fouling/engine flooding due to the lack of
incoming air. This will cause the engine not to start.
If engine starts after 3 pulls but fails to run, or if
unit shuts down during operation, make sure unit
English
20
8. Pull the starter cord slowly until resistance is
pull rapidly.
fuel valve to the "ON"(l)
9.
Push the
button to the "RUN"
engine switch to the "RUN"(l) position.
at no load
fewminutes upon each initial
permit engine and generator to
cord kickback(rapid retraction) will
bones, fractures, bruises, or sprains resulting in
serious injury.
When starting engine, pull cord slowly until
resistance is felt and then pull rapidly to avoid
kickback.
is on a level surface and check for proper oil level
in crankcase. This unit may be equipped with a low
oil protection device. If so, oil must be at proper
level for engine to start.

Manual Choke Start

(When the battery is dead)
If the battery is dead or not able to produce
enough current to power the push button choke,
the choke itself can be operated manually to help
10. Allow generator to run
WARNING
Customer Service: 1-844-FIRMAN1Page
felt and then
choke
position.
for
start-up to
stablize.
pull hand
6.
Push

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido