Assembly; Install The Wheel Kit; Install The Support Leg; Install The Handle - Firman P08004 El Manual Del Propietario

ASSEMBLY

The generator requires some assembly prior to
when assembling the
call 1-844-347-6261.

Install the Wheel Kit

CAUTION
The wheel kit is not intended for over-the-road
use.
side.
2. Slide the axle pin A through the wheel B.
3. Slide the axle pin A through the mount point
4. Secure the wheel and axle pin with the cotter
5. Repeat steps 2-4 to attach another wheel.

Install the Support Leg

1. Attach the support leg G to the
generator frame with flange bolts E (M8x16) and
flange lock nuts F(M8).
2. Tip the generator slowly so that it rests
on the wheels and support leg.
3.Tighten bolt E and nut F with provide
English
1. Place the handle K over the mounting channel usage. If problems arise
2. Secure the handle to the frame using the two
each bolt and fasten securely with provided
wrenches.

Install the Handle

on the frame. generator,
handle flange bolts H(M8x50).
3. Place a flange nut F (M8) on the end of
wrenches.
DO NOT over tighten the flange nuts.
1. Before adding wheels, tip the generator on
on the frame and flat washer D.
pin C.
Customer Service: 1-844-FIRMAN1
its