Task And Function - Prebena PKT-8-PR100 Traducción Del Manual Del Usuario Original

Description

Task and function

Task
Fastener driving tool PKT-8-RKP100 drives in round head nails 65-
100 mm long with a shaft diameter of 2.8–3.1 mm.
Fastener driving tool PKT-8-PR100 drives in half head nails 65-
100 mm long with a shaft diameter of 2.8–3.1 mm.
The nails may only be driven into wood materials with a maximum
strength of C30 in accordance with EN 338.
Functional principle
The nails are driven into the wood material by compressed air. The
energy sources are the pressure accumulator, which can be filled
with cartridge KT-1000, and the rechargeable battery.
The tool has two triggering processes for nail driving:
Single triggering with safety follow-up
A triggering process that allows one single driving process generated
by the triggering mechanism after the triggering safety device has
been activated. Additional driving processes can only be triggered if
the triggering mechanism and triggering safety device have returned
to the original position.
Contact triggering with automatic reset
The triggering mechanism is printed and held. In this state, every
time the triggering safety device is pressed within 5 seconds, a
driving process is generated. After 5 seconds without any contact
with the material, the tool goes back to single triggering.
For adjustments to the triggering process see page 46.
27