Checking The Function - Prebena 1GP-ALK35 Manual Original

Checking the function

Proceed as follows to check the function of the tacker:
CAUTION
 Note the danger warnings in the section on "Safety" from page
7 onwards.
 Set the tool lug of the tacker on a piece of wood with a minimum
thickness of 40 mm.
 Trigger the tacker (see the "Triggering tool" section on page 22).
 Check the following properties:
-
Every time the tool is triggered, a fastener must be driven into
the piece of wood.
-
To achieve the desired driving depth, alter the operating
pressure of the compressor (see page 15).
 Repeat these steps if necessary.
The tacker is now ready to use.
Preparing the tacker
19