Eu Declaration Of Conformity; Safety Regulations - i.safe MOBILE IS655.RG Guia De Inicio Rapido

ENGLISH
INTRODUCTION
This document contains information and safety regulations which are to be observed without
fail for safe operation of the device IS655.RG under the described conditions. Non-observa-
nce of this information and instructions can have serious consequences and / or may violate
regulations.
Please read the manual and these safety instructions before using the device. In case of any
doubt, the German version shall apply.
The current EU-declaration of conformity, certificate of conformity, safety instructions and
manuals can be found at www.isafe-mobile.com, or requested from i.safe MOBILE GmbH.
RESERVATION
The content of this document is presented as it currently exists. i.safe MOBILE GmbH does
not provide any explicit or tacit guarantee for the accuracy or completeness of the content
of this document, including, but not restricted to, the tacit guarantee of market suitability
or fitness for a specific purpose unless applicable laws or court decisions make liability man-
datory. i.safe MOBILE GmbH reserves the right to make changes to this document or to
withdraw it any time without prior notice. Changes, errors and misprints may not be used
as a basis for any claim for damages. All rights reserved.
i.safe MOBILE GmbH cannot be held responsible for any data or other loss and direct or
indirect damages caused by any improper use of this device.
EU-DECLARATION OF CONFORMITY
The EU-declaration of conformity can be found at the end of this manual.
FAULTS AND DAMAGES
If there is any reason to suspect that the safety of the device has been compromised, it must
be withdrawn from use immediately. Measures must be taken to prevent any accidental
restarting of the device. The safety of the device may be compromised, if, for example:
Malfunctions occur.
The housing of the device shows damage.
The device has been subjected to excessive loads.
The device has been stored improperly.
We recommend that a device displaying errors or in which an error is suspected be sent back
to i.safe MOBILE GmbH to be checked.

SAFETY REGULATIONS

Use of this device assumes that the operator observes the conventional safety regulations and
has read and understood manual and safety instructions.
The following safety regulations must also be complied with:
To ensure the IP-protection, it has to be ensured that all gaskets are present and functional.
There must be no large gap between the two halves of the housing.
The device may only be charged at ambient temperatures between 5°C ... 35°C.
4