Uline H-2319 Manual De Instrucciones página 3

FASTEN CASTER TO LEGS
1. Take both legs from Package 1 position them to
form a "V".
2. Attach front casters fully using one bolt, one nut,
and two washers per hole. (See Figure 1)
3. Attach the rear casters, using only the two holes
closest to leg bar.
CAUTION! Do not tighten nuts all the way: this
allows other nuts to be positioned correctly.
ATTACH MAIN POST TO LEG ASSEMBLIES
1. Lay black main post on ground and align
mounting plate holes with rear leg assembly holes.
2. Use two (2) bolts on each side to secure post to leg
assembly. (See Figure 2)
3. Tighten all locknuts securely.
PAGE 3 OF 15
ASSEMBLY
ATTACH FILM HOLDER
1. Stand Main Post upright.
2. Place Film Holder over top of post and slide all the
way down. (See Figure 3)
3. Tighten knob on Film Holder to secure in place.
Figure 3
INSTALL STEERING HANDLE
Figure 1
1. Slide Steering Handle over Main Post. (See Figure 4)
2. Position to operator height. (Approximately waist
level). Tighten knob to secure in place.
INSTALL TOP HEAD ASSEMBLY
1. Slide Top Head Assembly over Main Post.
2. Tighten the lock knob on Head Assembly. When film
Figure 2
is installed, position Head Assembly 4" above film.
(See Figure 5)
Figure 4 Figure 5
0721 IH-2319