Uline H-2319 Manual De Instrucciones página 4

LOADING FILM INTO THE DISPENSER
1. Adjust Lower Film Holder to desired height. It can
be adjusted to wrap the bottom of the pallet or
adjusted to wrap at any position on the load.
2. To wrap pallet clockwise, place film on lower Film
Holder so that the film will feed off roll counter
clockwise. (See Figure 6)
3. To wrap pallet counter-clockwise, place film on
lower Film Holder so that the film will feed off roll
clockwise.
4. Carefully lower head assembly onto film core and
secure with knob.
CAUTION! No force is required because the
Head Assembly has a self-locking core.
APPLYING FILM TO PALLET
1. With the Stretch Set™ knob in the OFF position, unroll
film and attach securely to pallet.
NOTE: Tying a knot in the end of the film often
helps secure film to pallet.
SETTING FILM STRETCH LEVEL
1. Engage Stretch Set™ by sliding knob down to the
ON position. This engages the Film Stretch System.
2. To increase Stretch level, turn Stretch Set™ knob
clockwise.
NOTE: Even ¼ turn (90˚) adjustments
noticeably increase film stretch. Stretch level
will not change until more adjustments are
made.
PAGE 4 OF 15
OPERATION
WRAPPING THE PALLET
1. Grab the cushioned steering arms.
2. While film is feeding off the roll, you must wrap your
product by PULLING the dispenser around the pallet
insuring the film will not come in contact with the
lower legs of the dispenser. (See Figure 6)
FINISHING WRAPPING THE PALLET
1. Cutting the film approximately 12" past a corner is
suggested. Note: It is easier to cut the film if Stretch
Set™ is in the ON position. (See Figure 7)
Figure 6
Figure 7
2. Stretch film cuts easily if torn at a 45˚ degree angle
to itself. (See Figure 8)
Figure 8
CHANGING FILM ROLLS
1. Rotate empty core 1/4 turn in opposite direction of
film feed. Core is now free.
2. Slide off top core assembly and remove empty roll.
3. Load new roll onto dispenser (see above).
0721 IH-2319