Uline H-4068 Instrucciones De Montaje

H-4068, H-4069, H-4072
π
H-5012, H-5013, H-5014
H-5015, H-5016, H-5017
GRAVITY ROLLER
CONVEYORS
TOOL NEEDED
9/16" (14mm) Wrench
BOLTING CONVEYOR FRAME(S)
TO H-STAND LEG SUPPORTS
NOTE: H-Stands are sold
separately. Hardware
included: 4 hex head bolts,
4 flange nuts.
1. Hardware is prescrewed into the
tops of the H-Stands. Remove
the hardware. (See Figure 1)
2. Bolting two H-Stands to one
conveyor frame: Position
H-Stands on the end of
the conveyor frame.
Fasten bolts through
conveyor and H-Stand.
(See Figure 2)
Bolting a single H-Stand to
two conveyor frames:
Position the H-Stand halfway
between the end of two
conveyor frames,
lining up one hole
on each conveyor
with the H-Stand.
Fasten bolts through
conveyors and H-Stand.
(See Figure 3)
NOTE: Each conveyor
frame includes mounting
holes for an optional center
leg support. Adding a third
support increases weight
capacity.
PAGE 1 OF 3
1-800-295-5510
uline.com
ASSEMBLY INSTRUCTIONS
CONNECTING MULTIPLE CONVEYOR
FRAMES TOGETHER
1. Lift the hook over the bolt to keep it in place.
(See Figure 4).
Figure 1
Figure 2
Figure 3
Para Español, vea página 2.
Pour le français, consulter la page 3.
Figure 4
0621 IH-4068