Before Assembly - Kettler Classic Flyer 12 Retro Trike Instrucciones De Montaje

USA Before Assembly
Use of the Toy

Ensure that the toy vehicle is not used until it has been properly assembled and checked by an adult person.

Always adjust the use of the toy vehicle to the conditions encountered.

This toy vehicle does not possess a continuously effective brake system. Therefore, safeguard the scooter against
rolling away when parking it. Never park the toy vehicle unattended with a child on it!

Instruct your child how to use the toy vehicle correctly and draw attention to possible sources of danger.

Although dangerous situations are unlikely to occur if the ride‐on is used correctly, children at play should, if
possible, be supervised.

Please bear in mind that there is always a danger of children injuring themselves while using swings, climbing
frames, toy vehicles or similar equipment.

When children are at play, situations may arise which cannot be predicted by the manufacturer and for which he
cannot be held responsible.

Before use, always check all screws and plug‐in connections as well as respective safety devices fit correctly.

Never use corrosive or abrasive substances to clean the ride‐on. Never use substances which may cause pollution of
the environment.

For models with pneumatic tires: Due to the nature of materials used in pneumatic tires, it is not recommended for
the product to be left in any one place for too long where solvents or other chemicals, i. e. oil, may lie. This may
result in a chemical reaction, which could cause the tires to mark the surface such as a vinyl flooring. If in doubt put
something underneath the wheels to cover the floor. Ensure that air pressure in the tires is correct; if air pressure is
too low this increases wear, and makes riding the balance bike more difficult!

Lubricate the bearing sleeves of the wheels and the handlebars with a few drops of oil every two or three months.
All manuals and user guides at all-guides.com