Marmitek Stream S2 Pro Manual De Instrucciones página 4

Safety instructions
Please read these instructions thoroughly before you
use the device and keep them for future reference.
This product is not a toy. Keep out of reach of
•
children.
Repairs or service should only be performed by
•
qualified personnel.
Requirements
For AirPlay use iOS 9.0 or above
•
For Miracast use Android 5.0 or above
•
Step 1: Installing the Stream R2 Pro (receiver)
1. Plug the HDMI stick into the HDMI input of the display
or projector. If necessary, use the optional HDMI
extension cable for optimal placement.
2. Use the USB 2.4 GHz cable as power supply for the
Receiver by plugging it into a free USB port of the
display or projector.
Receiver LED status:
Blue (blinking) – waiting for connection
Blue – connected
Step 2: Installing the Stream T2 Pro (transmitter)
1. Plug the HDMI stick into the HDMI output from the
source (e.g. laptop or any other HDMI device).
2. Some source devices can supply enough power
through HDMI output to the Transmitter. Use the USB
power cable when Transmitter is not working properly
due to power shortage.
3. If necessary, use the optional HDMI adapter (male >
female) for optimal placement and installation.
4
Transmitter LED status:
Red – starting up
Red (blinking) – searching for Receiver
Blue (blinking) – waiting for connection
Blue – connected
Purple – no HDMI signal
Step 3: Pairing additional transmitters (optional)
The Transmitter and Receiver supplied in this set are
already paired. However, when adding an additional
Transmitter (Stream T2 Pro) it must be paired with the
Receiver.
1. Power ON the Receiver and wait until it has started
up and the home page appears on the screen.
2. Ensure all other available Transmitters are powered
OFF.
3. Power ON the Transmitter and wait around 15
seconds. The indicator LED will change from static red
to static blue and "Pairing Successful" will appear on the
screen.
Step 4: Connect the Receiver to your Wi-Fi (optional)
The Receiver can be connected to your wireless router
through Wi-Fi for easy connection with AirPlay and
Miracast.
1. Open the Wi-Fi settings on your laptop or smart
device, connect to the SSID "Stream S2 Pro" and enter
the password displayed on the screen.
2. Open the browser on your laptop or smart device and
enter the IP address displayed on the screen.
3. Select the SSID from the wireless router and enter
the password.
4. Once connected the SSID from the wireless router is
displayed on the screen.
© MARMITEK