Dash Disassembly - Metra 99-6506 Instrucciones De Instalación

1. Loosen (1) T-15 Torx screw from the front
side of the shift knob and pull up to
remove. (Figure A)
Note: For models equipped without a
release lever on the shift knob, just turn
counter-clockwise to remove.
2. Unsnap the floor console trim around
the shifter. Unplug the harness to
console trim and remove the trim.
(Figure B)
3. Unsnap and remove the ignition
key trim ring.
2

DASH DISASSEMBLY

P
R
N
D
K C T I S O T U A
(Figure A)
P
R
N
D
K C T I S O T U A
(Figure B)
4. Unsnap and remove the dash trim
panels from each side of the radio/
climate controls. (Figure C)
5. Remove (4) Phillips screws to
remove the radio.
Note: When installing a DIN radio, a
piece of plastic in the dash cavity may
have to be removed for radio clearance
(Figure D).
Continue to Kit Assembly
(Figure C)
POWER
POWER
OUTLET OUTLET
(Figure D)
|
1.800.221.0932 MetraOnline.com