Final Setup; Important Considerations - Heath Zenith 5838 Manual De Instrucciones

LAMP HEAD ADJUSTMENT
This light is designed with four adjustable lamp heads. The lamp heads
can be used as two lamp heads or can be separated to help spread the
light coverage. Caution should be taken not to rotate the lamp heads
past the built-in stops.
1. Gently grasp the top lamp heads and move them to cover the
desired area.
2. Gently grasp the bottom lamp heads and move them to cover
the desired area.
Set the amount of ON-TIME you want the lights to stay on after all
motion has stopped (1, 5, or 20 minutes).

IMPORTANT CONSIDERATIONS

AVOID AIMING THE SENSOR AT:
• Below are examples of objects that might produce heat and may cause the motion sensor to trigger:
• Pools of Water
• Animals
If you suspect that a heat source of this type is triggering the motion sensor, reduce the sensitivity.
• Areas where pets or traffic may trigger the motion sensor.
• Nearby large, light-colored objects reflecting light may trigger the shut-off feature. Do not point other lights at the
motion sensor.
SEASONAL CHANGES:
The motion sensor works by sensing temperature changes across its field of view. The closer the surrounding tempera-
ture is to a person's body heat, the less sensitive the sensor will appear. The greater the temperature difference, the more
sensitive the sensor will appear. The sensitivity (SENS) switch might need to be readjusted as the outside temperature
changes for the different seasons. This is a normal part of the light sensor's operation.
210008-02

FINAL SETUP

• Air Conditioners
• Heating Vents
To see operational and troubleshooting information and videos,
• Dryer Vents
• Automobile Traffic
go to www.hzsupport.com
THIS SIDE UP
5