Compulsary Inspections And Checks; Storage And Maintenance - Tractel TB1 0-150 Manual De Empleo

COMPULSARY INSPECTIONS AND CHECKS

All maintenance inspections and operations must be performed by qualified specialists.
▪ Check on start up (or starting back up): in compliance with the national regulations.
▪ Compulsory periodical check in compliance with the national regulations. Recommended every 12
months by TRACTEL SOLUTIONS SAS.
▪ A thorough examination paying particular attention to any alteration of parts due to an impact, corrosion,
cracking or deformation must be conducted at least twice a year, and every month in the case of heavy-
duty use or in an aggressive atmosphere.
▪ TRACTEL SOLUTIONS SAS is at your disposal in order to conduct any regulatory check.
Before each use
▪ Visually inspect the hook.
Full inspection
▪ According to French regulation, hooks used in manufacturing, must be checked each year. This annual
control must include all necessary examinations in order to detect any damage or potential problems that
could cause dangerous situations.
▪ Check if equipment doesn't have any deformation, fissures or other defaults.
▪ Check presence and legibility of engraved information or signalling plate.
▪ Note all controlled information on a register.
Storage
Correctly store the instructions for use with the hook. Keep the material in a dry place, protected from bad
weather.
Maintenance of the equipment
All maintenance inspections and operations must be performed by qualified specialists.
▪ Regularly check the equipment is in perfect working order (before every use).
▪ Perform visual inspection before every use.
▪ Any part with a defect must be replaced by a TRACTEL SOLUTIONS SAS genuine part.
▪ Any deformed equipment must be immediately withdrawn from use.
M 6071 M
rev 11 – 06/2021
GB

STORAGE AND MAINTENANCE

N
Page 16/40
www.tractel.com