Waterpik SinuSense Folleto De Instrucciones página 4

Save these instructions.
®
The Waterpik SinuSense
Your Waterpik® SinuSense™ Water Pulsator comes with 2 removable self-sealing SoftSeal™ nozzles,
1 water reservoir, 1 fl ow tube, 3 AA batteries, and 1 water pulsator.
For best results, practice sinus washing with the Waterpik® SinuSense™ Water Pulsator 1–2 times
per day. Begin with 1 Soothing Saline Easy-Pour pack mixed with warm distilled water (warm tap
water may be used but is not recommended). If your nasal passage is completely blocked or if you
have an ear infection or are experiencing pressure in the ear, discontinue nasal rinsing and consult
your physician.
6 E N G L I S H
All manuals and user guides at all-guides.com
™
Water Pulsator
1 4
or
2 5
a
2 6
b
3
Meijer.com
Preparing Your
® ™
Waterpik SinuSense
Water Pulsator for Use
1. If the blue reservoir is attached to the white
housing, remove by gently turning the reservoir
clockwise a quarter turn.
2. Use a standard screwdriver or coin to loosen (but
not remove) the center screw on the gray battery
cover. It will take approximately 5 complete
turns. Note: screw will remain in battery cover.
3. Pull slightly on the gray battery cover to reveal
battery compartment.
4. Install 3 AA batteries following the diagram
inside battery compartment.
5. Replace the gray battery cover. Align the raised
tick marks on the white housing and the gray
battery cover. The hose fi tting will be centered in
the middle window.
6. Hold the gray battery cover fi rmly against
the white housing while tightening the screw
securely on the battery cover.
E N G L I S H 7