Schumacher Electric SC-8010A Manual Del Usuario página 10

Cargadores de batería automático
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PROBLEM
The charger is making
an audible clicking sound
(continued).
Charger makes a loud buzz
or hum.
CONNECTED (yellow) LED
is not on.
CONNECTED (yellow) LED
is blinking.
Short or no start cycle when
cranking engine.
All manuals and user guides at all-guides.com
POSSIBLE CAUSE
Shorted battery cables or
clips.
Severely discharged battery,
but otherwise it is a good
battery.
Reverse connections at
battery.
Transformer laminations
vibrate (buzz).
Clips are not making a good
connection to the battery.
Connections are reversed.
Battery is defective (will not
accept a charge).
Indicates the charger is in
abort mode.
Drawing more than the
Engine Start rate.
Failure to wait 3 minutes (180
seconds) between cranks.
Clips are not making a good
connection.
AC cord and/or extension
cord is loose.
No power at receptacle.
The charger may be
overheated.
Battery may be severely
discharged.
• 9 •
REASON/SOLUTION
Circuit breaker cycles when
current draw is too high.
Check for shorted cables or
clips and replace if necessary.
The battery may not want to
accept a charge due to a run-
down state. Allow charging to
continue until battery has a
chance to recover sufficiently
to take a charge. If more than
20 minutes, stop charging and
have the battery checked.
Shut the charger off and
correct the lead connections.
No problem, this is a normal
condition.
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Rock clips back and forth for a
better connection.
Unplug the charger and
reverse the clips.
Have battery checked.
See "Aborted Charge" in the
OPERATING INSTRUCTIONS
Section.
Crank time varies with the
amount of current drawn. If
cranking draws more than the
Engine Start rate, crank time
may be less than 3 seconds.
Wait 3 minutes of rest time
before the next crank.
Check for poor connection at
battery and frame.
Check power cord and
extension cord for loose fitting
plug.
Check for open fuse or circuit
breaker supplying AC outlet.
The thermal protector may
have tripped and needs a little
longer to reset. Make sure the
charger vents are not blocked.
Wait and try again.
On a severely discharged
battery, charge for 10 to 15
minutes in the 10◄►25 amp
charge rate to help assist in
cranking.

Publicidad

Tabla de contenido
loading

Tabla de contenido