Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
90577318 FME600K Oscillating Tool Manual.qxd:??????-00 Cir Saw book
MAINTENANCE
CAUTION: Never use solvents or other harsh chemicals for cleaning the non-metallic
parts of the tool.
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Use only identical replacement parts. For a parts list or to order parts, visit our service website at
REPLACEMENT PARTS
www.stanleytools.com. You can also order parts from your nearest Stanley FatMax Factory
Service Center or Stanley FatMax Authorized Warranty Service Center. Or, you can call our
Customer Care Center at (800) 262 2161.
All quality tools will eventually require servicing and/or replacement of parts. For
SERVICE AND REPAIRS
information about Stanley FatMax, its factory service centers or authorized warranty
service centers, visit our website at www.stanleytools.com or call our Customer Care
Center at (800) 262 2161. All repairs made by our service centers are fully guaranteed
against defective material and workmanship. We cannot guarantee repairs made or
attempted by others.
You can also write to us for information at Stanley Tools, 701 E. Joppa Road, Towson,
Maryland 21286 - Attention: Product Service. Be sure to include all of the information
shown on the nameplate of your tool (model number, type, serial number, etc.).
Since accessories, other than those offered by Stanley FatMax have
ACCESSORIES
not been tested with this product, use of such accessories with this tool could be
WARNING:
hazardous. To reduce the risk of injury, only Stanley FatMax recommended accessories
should be used with this product.
A complete line of accessories is available from your Stanley FatMax Factory Service
Center or a Stanley FatMax Authorized Warranty Service Center. Please visit our Web
• Unit will not start.
Problem
For assistance with your product, visit our website at www.stanleytools.com. for a list of
service centers, or call the Stanley FatMax Customer Care Center at (800) 262-2161
Site www.stanleytools.com for a catalog or for the name of your nearest supplier.
TROUBLESHOOTING
• Cord not plugged in.
Possible Cause
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
10
12/12/11
• Plug tool into a working outlet.
Possible Solution
• Replace circuit fuse. (If the
product repeatedly causes the
circuit fuse to blow, discontinue
use immediately and have it
serviced at a Stanley FatMax
service center or authorized
servicer.)
• Reset circuit breaker. (If the
product repeatedly causes the
circuit breaker to trip,
discontinue use immediately
and have it serviced at a Stanley
FatMax service center or
authorized servicer.)
• Have cord or switch replaced
at a Stanley FatMax Service
Center or Authorized Servicer
10:07 AM
Pag
Publicidad
Tabla de contenido
