Assembly Of Roundtop; Garage Shelter; Plotting And Squaring Up The Frame; Assemble End And Middle Ribs - ShelterLogic 201133 Instrucciones De Asamblea

ASSEMBLY OF ROUNDTOP

NOTE FOR FRAME EXTENSION KIT: 12' x 20' x 8' is the base frame dimension. Your model may have more
middle ribs than shown in the illustrations. You will receive one extra rib for every extra 4 feet of building length
that you purchase. The basic frame assembly will remain the same. The cover will be the correct size for the
length of the building ordered.

1. PLOTTING AND SQUARING UP THE FRAME:

A. Before building your shelter, you should choose a flat area
on your property and plot your shelter. Stake out the area for
the frame in the desired spot. Check that it measures 12' in
width and the length would be determined by the size shelter
you purchased. Tie a rope diagonally from corner to corner.
B. Measure across area, end to opposite end. See Detail A.
The measurement A and B should be equal.

2. ASSEMBLE END AND MIDDLE RIBS:

A. Assemble end and middle ribs as shown in Detail B and Detail C.
Securely fasten all of the joints with the hardware indicated.
DETAIL b
End Ribs
#10210
10224 10225
3" Bolt
2"
Bolt
10223
10' HIGH
10226
#10210
10224 10225
3" Bolt
2"
Bolt
10226
8' HIGH
05-201133_13-0D
®

GARAGE SHELTER

12'
A
b
DETAIL A
12'
DETAIL C
Middle Ribs
10224
#00669
3-1/2" Bolt
2"
Bolt
10223
10223
10273
10226
10224
#00669
3-1/2" Bolt
2"
Bolt
10273
10226
Page 6

3. INSTALL SIDE RAILS AND SHELTERLOCk

A. Place assembled first end rib in the staked area. Place the
ShelterLock ™ on the upright as shown in Detail D. from the
outside of the rib insert the bolt through the upright and then
through the ShelterLock
B. Place the plain end of the side rail over the bolt and nest
it into the ShelterLock
tighten. Repeat these steps for the opposite side and all of
the remaining ribs. The side rails for the last rib will have two
plain ends.
LENGTH
OF
bUILDING

4. INSTALL WIND BRACES:

A. Attach wind brace between the end rib and the first
middle rib as shown in Detail e. Bolts attached at the
cross rails should be inserted facing inside the shelter.
10225
10223

5. INSTALL TOP RAIL:

A. Place the first top rail under each end rib and secure it
with a bolt as shown in Detail f. The same cross rail should
10273
lay on top of the all middle ribs. Secure the rails to the frame
with the hardware indicated in Detail f. The top rail attached
to the last rib will be installed under the pipe.
10225
DETAIL F
10273
™

STABILIzER BLOCkS:

.
™
™ . install the nut onto the bolt and
END RIb
10205
wIND
bRACE
Install the Top Rail
OvER all Middle Ribs
UNDER First and Last Ribs
10210
00669
Page 7
DETAIL D
800260
10210
01010
FIRST
MIDDLE
RIb
DETAIL E 10205
wIND
bRACE
05-201133_13-0D