Remove Contents From Carton; Assembly - Generac GP Serie El Manual Del Propietario

Remove Contents from Carton

1. Open carton completely by cutting each
corner from top to bottom.
2. Remove and verify carton contents prior to
assembly. Carton contents should contain
the following:
TABLE 3. Accessories
Item
Main Unit
Owner's Manual
Liter Oil SAE 30 with Funnel
Handle Assembly (A)
Never-flat Wheel (B)
Frame Foot Assembly (C)
Axle Pin (D)
Product Registration Card
Service Warranty
Emissions Warranty
Hardware Bag
Handle Bracket (E)
Cotter Pin (F)
M8-1.25 Hex Flange Nut (G)
M8-1.25 x 40 Hex Head Bolt (H)
M8-1.25 x 45 Bolt (J)
M8-1.25 x 55 Bolt (K)
Flat Washer (L)
3. Call Generac Customer Service 1-888-
GENERAC (1-888-436-3722) with the unit
model and serial number for any missing
carton contents.
4. Record model, serial number, and date of
purchase on front cover of this manual.

Assembly

Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
Call Generac Customer Service at 1-888-
GENERAC (1-888-436-3722) for any assem-
bly issues or concerns. Please have model
and serial number available.
Owner's Manual for Portable Generator
WARNING
(000100a)
The following tools are required to install the
accessory kit.
• Needle nose pliers
• Ratchet
• 12mm socket
• 12mm wrench
NOTE: The wheels are not intended for over-
the-road use.
Install wheels as follows. See
1. Slide axle pin (D) through the wheel (B),
Qty.
wheel bracket on frame, and flat washer
1
(L).
2. Insert cotter pin (F). Bend tabs (of cotter
1
pins) outward to lock into place.
1
Install frame foot as shown in
1. Place frame foot assembly (C) under
1
frame. Secure with M8-1.25 x 45 bolts (J)
2
and M8-1.25 hex flange nut (G).
.
2
2
3
1
1
B
Qty.
1
2
5
2
Figure 2-6. Wheel & Frame Foot Assembly
Install handle as shown in
4
1. Install handle bracket (E) to frame with
1
M8-1.25 x 40 bolts (H).
2
2. Slide M8-1.25 x 55 bolts (K) through han-
dle bracket and handle (A). Install M8-1.25
hex flange nut (G).
.
D
L
F
Figure 2-7. Handle Assembly
Figure 2-6.
Figure 2-6.
J
000902
G
C
Figure 2-7.
E
K
H
A
G
000903
7