Remove Contents From Carton; Assembly - Generac XT Serie El Manual Del Propietario

0000.0
Figure 2-7. Hour Meter

Remove Contents from Carton

1. Open carton completely by cutting each
corner from top to bottom.
2. Remove and verify carton contents prior to
assembly. Carton contents should contain
the following:
TABLE 3. Accessories
Item
Main Unit
Owner's Manual
Product Registration Card
Warranty and Emission Sheets
Quart SAE Oil
20 ft. Extension Cord
Battery Charger
Oil Funnel
Hardware Bag
Cotter Pin (A)
Washers (B)
Never-flat Wheels (C)
Axle Pins (D)
Frame Foot Assembly (E)
Hex Flanged Nuts (M8) (F)
Hex Bolts (M8) (G)
Gasket (H)
Control Guard (J)
Allen Screw (4 mm) (K)
Handle Assembly (L) (not in hardware
bag)
Hex Bolt (M8 x 55 mm (M)
Nylon Washer (N)
Hex Lock Nut (P)
Allen Hex Wrench (4 mm) not shown
Owner's Manual for Portable Generator
3. Call 1-888-GENERAC (1-888-436-3722)
with the unit model and serial number for
any missing carton contents.
4. Record model, serial number, and date of
purchase on front cover of this manual.

Assembly

Consult Manual. Read and understand manual
completely before using product. Failure to
000205
completely understand manual and product
could result in death or serious injury.
Call 1-888-GENERAC (1-888-436-3722) for
any assembly issues or concerns. Please
have model and serial number available.
The following tools are required to install the
accessory kit.
• Ratchet Wrench (1)
• 8mm Wrench (2)
• 13mm Wrench (1)
• 13mm Socket (1)
• Needle Nosed Pliers (1)
Qty.
NOTE: The wheels are not intended for over-
the-road use.
1
See Figure
1
Install wheels as follows:
1
1. Slide axle pin (D) through the wheel (C)
and generator frame axle holes.
1
2. Slide one 5/8" flat washer (B) onto axle
1
and secure with cotter pin (A). Repeat on
opposite side.
1
1
1
Qty.
2
2
2
2
2
4
4
See Figure
Install frame foot assembly as follows:
1
1. Slide M8 hex bolts (M) through holes in
1
frame.
2. Slide frame foot (E) on to hex head bolts
4
(G).
1
3. Install locking flange nuts (F) and tighten
with a ratchet, 13mm socket and 13mm
wrench.
2
Install gasket and control guard as follows:
4
1. Place gasket (H) and control guard (J) in
2
place against side panel opening.
2. Loosely install Allen screws (K). Tighten
1
with 4mm Allen wrench.
WARNING
2-8.
A B
Figure 2-8. Wheel Assembly
2-9.
(000100a)
C
D
004543
7