Lock And Key - Uline H-2273 Manual De Instrucciones

Figure 3
Figure 4
Figure 5
• The standard lock with a removable standard key is
provided for security.
PAGE 2 OF 6
LOADING CONTINUED
1. Tuck the paper behind and under the white roller.
Twist the knob located on the right-hand side until
the paper feeds through the clear dispensing
module. (See Figure 3)
STUB ROLL LOADING
1. Remove the remaining stub roll from the roll support
arms without unthreading the paper and place in
the stub roll tray at the bottom of the dispenser.
(See Figure 4)
2. Place a new roll on the roll support arms with the
paper unwinding from the back.
3. Place the end of the new roll of paper under the
blue transfer clips. (See Figure 5)
4. When the stub roll is exhausted, a user can start the
pre-loaded roll by turning the knob two full turns.

LOCK AND KEY

• If a keyed lock is not required, a snap-in key is
provided. The snap-in key is installed by pushing it
down firmly into the lock and rocking it slightly until it
snaps.
1-800-295-5510
uline.com
NOTE: Using the blue transfer clips to load a
new roll is unnecessary.
0721 IH-2273