Maintenance And Care - Uline H-2243 Manual Del Usuario

Operate machine switched on, tape loaded and water
in reservoir.
1.
For pre-set lengths of tape press the numbered key
that corresponds to the desired length.
2.
Add 2" to pre-set lengths. For example, to make a
10" length of tape: First, push the +2 key (light comes
on), then push the 8 key. Dispenser makes a 10"
length of tape. Push the +2 key again to turn off
this feature.
3.
For custom tape lengths press and hold the
green Random Length key until the desired length is
dispensed.
PROGRAMMING TWO LENGTHS OF TAPE
You can program the dispenser to memorize one or two
different tape lengths with the Short Length and Long
Length keys.
NOTE: Programmed keys must be reset each
time the dispenser is switched on.
1.
Set Short Length – While holding down the Short
Length key, press the number key that corresponds
to the shorter length desired.
2.
Release both keys to set the short length.
CAUTION! Only trained personnel should be
allowed to operate or service this machine.
WEEKLY MAINTENANCE
1.
Wash the moistening brush with soap and warm
water. Rinse thoroughly with water.
2.
Clean the dispenser using compressed air
(NEVER WATER) to clean off dust and dirt.
PAGE 4 OF 15
OPERATION
3.
4.
5.
6.
PROGRAMMING INTERMEDIATE LENGTHS OF TAPE
Use this procedure to dispense intermediate lengths of
tape (example, 18" or 22" lengths)
1.
2.
WHEN DISPENSER IS NOT IN USE
Always switch power off.

MAINTENANCE AND CARE

MONTHLY MAINTENANCE
1.
2.
3.
Set Long Length (Second Length) – While holding
down the Long Length key, press the number key
that corresponds to the longer length desired.
Release both keys to set the long length.
Use the Short Length key to dispense your shorter
length and the Long Length key to dispense the
longer length.
Slide the color-coded sliding indicators next to the
number keys to mark your two chosen lengths.
Press the +2 key (indicator light is on). This adds 2" to
any pre-set number key you choose.
Follow Steps 1-6 in "Programming Two Lengths of
Tape."
Lubricate the cutting blades with a drop of oil.
Clean the rubber tape advance wheel with water.
DO NOT grease or oil the wheel. Access the wheel
by removing the upper paper guide.
Clean the water reservoir with soap and water.
Rinse thoroughly.
0621 IH-2243