TECO 680 Manual De Instrucciones página 105

Exit key twice
- If a different working environment is recalled between one step of the OPT programme
and the next one, the OPT procedure always remains stored. Therefore, going back to
the start environment, the programme resumes the execution from the point where it
was interrupted. This situation is possible when the Temporary Exit icon is selected.
Weight Right is a suite containing 4 programmes:
1. Hidden Weight
2. Split Weight
3. OPT flash
4. Minimum Weight.
Note: the Hidden Weight, Split Weight and OPT Flash programmes are available
even when Weight Right is not enabled.
To access this suite you must:
• select the Utility programmes icon;
• select the Weight Right icon .
In this way you will access the main screen of Weight Right, showing 4 icons:
1. the OPT Flash icon for the unbalance minimisation programme;
2. the Balancing programme icon that unites all the available balancing programmes;
3. the Statistics icon that visualises the statistics relating to the use of the Minimum
Weight programme;
4. the Minimum Weight icon for the slow or fast vehicles weight savings programmes.
If programme ALU 1P or ALU 2P has been set to "auto" mode, the Hidden weight icon
will also appear, while if the programme ALU MOTO has been set in "motorcycle" mode,
the Divide side weight icon will appear.
Note: for Balancing programmes refer to the BALANCING PROGRAMMES paragraph.
Note: for the OPT Flash programme, see the paragraph OPTIMISATION PRO-
GRAMME (OPT FLASH).
Weight savings programme (minimum Weight)
This programme allows you to obtain the optimum balancing of the wheel, reducing the
quantity of weight to be applied to a minimum.
To access this programme you must:
• select the Utility programmes icon;
• select the Weight Right icon.
In this way you will access the main screen of Weight Right, and the unbalance values
visualised will be automatically updated.
Selecting the Minimum Weight icon , it is possible to choose between 2 different weight
savings programmes:
• optimised programme for fast vehicle wheels;
• optimised programme for slow vehicle wheels.
The status bar of the displayed screen will show:
• the Fast wheel icon, if the programme for fast vehicle wheels has been selected;
• the Slow wheel icon, if the programme for slow vehicle wheels has been selected.
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
.
WEigHT rigHT SUiTE
EN
105