Introduction - TECO 680 Manual De Instrucciones

inTroDUCTion

The purpose of this manual is to provide the owner and operator with effective and safe
instructions for the use and maintenance of the wheel balancer.
Follow all of the instructions carefully and your machine will assist you in your work and
give long-lasting and efficient service, in keeping with manufacturer traditions.
The following paragraphs define the levels of danger regarding the machine, associated
with the warning captions found in this manual.
DANGER
Refers to immediate danger with the risk of serious injury or death.
CAUTION
Dangers or unsafe procedures that can cause serious injury or death.
WARNING
Dangers or unsafe procedures that can cause minor injuries or damage to property.
Read these instructions carefully before starting the machine. Keep this manual and all
illustrative material supplied with the machine in a folder near it where it is readily ac-
cessible for consultation by the operators.
The technical documentation supplied is considered an integral part of the machine; in
the event of sale all relative documentation must remain with the machine.
The manual is only to be considered valid for the machine model and serial number
indicated on the data plate.
CAUTION
Adhere to the contents of this manual: The producer declines all liability in the
case of actions not specifically described and authorised in this manual.
NOTE
Some of the illustrations contained in this manual were derived from photos of prototypes:
the standard production machines may differ in some details.
These instructions are for the attention of personnel with basic mechanical skills. We have
therefore condensed the descriptions of each operation by omitting detailed instructions
regarding, for example, how to loosen or tighten the fixing devices on the machine. Do
not attempt to perform operations unless properly qualified and with suitable experience.
If in need of assistance, call an authorised assistance centre.
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
68