Switching On The Machine; General Notes On The Main Menu - TECO 680 Manual De Instrucciones

SWiTCHing on THE maCHinE

Connect the power supply cable (A, Fig.4a) supplied with the machine from the external elec-
trical panel located on the rear side of the wheel balancer body to the mains.
Switch on the machine using the switch on the rear side of the body (b, Fig. 4b).
The wheel balancer performs a checking test and, if no anomaly is detected, a beeper sounds
and the machine displays the customisation data and mark, then waits for the wheel geometric
data to be entered.
Pressing enter the image of the unbalance values is displayed; the initial active status
will be:
- dynamic balancing mode;
values displayed : 000 000;
- unbalance display at 5-g (or 1/4-of-an-ounce) increments;
- sensor value rounding-off active;
- default geometric values: width= 5.5", diameter = 14", distance = 150;
- operator 1 active.
Note: if the image is not centred on the LCD monitor, adjust it using the controls located on
the front part of the monitor. For further information on the adjustment procedure, refer to the
monitor manual provided, which can be found inside the packaging.
Now the operator can set the data of the wheel to be balanced or select one of the programmes
available.

gEnEral noTES on THE main mEnU

Graphics are completely icon-based (drawings and symbols that represent the function of
the button). If an icon is selected, the relevant function is activated.
Four icons can be found on the left part of the monitor:
help;
highest accuracy;
utility and configuration programmes;
balancing programmes.
To select the desired icon, use the arrow keys on the keypad until the selector
is above the desired icon. Select by pressing the Enter button
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
.
83
EN