Installing And Connecting The Mt200; Power Supply - Dometic WAECO MagicTouch MT200 AU4 Indicaciones Para El Montaje Específicas

_MT200_AU4.book Seite 13 Montag, 19. April 2010 7:26 19
MagicTouch MT200 AU4
The following information contains vehicle-specific installation instructions
for MagicTouch MT200. Refer to the installation and operating manual for any
further information.
1 Suitable for installing in the following vehicles
The MagicTouch MT200 AU4 radio remote control (item no. 9101300028) can be
used in the following vehicle types:
Audi A3 96 – 03
Audi A4 with TWS 95 – 97
Audi A4 97 to 02
Audi A6 with TWS 94 – 02
Audi A8 94 – 02
Audi Cabrio 91 – 00
Seat Arosa
Skoda Octavia LX & SLX 96 – 00
VW Lupo
TWS: theft warning system
2

Installing and connecting the MT200

NOTE
I
Use a red piercing connector for cables with a cross-section of max. 1 mm².
Use a blue piercing connector for cables with a cross-section of between
1.5 to 2.5 mm².
➤
Undo the strap on the negative terminal of the vehicle battery.
2.1

Power supply

Audi A3, A4, Skoda Octavia
The connection to the power supply is made on the driver's side at the fuse box
underneath the dashboard.
➤
Connect the following cables of the radio remote control as follows:
– Connect the red cable to the "+30" screw terminal (under the dashboard,
fig. 1 1, page 2)
– Connect the orange cable to the "75X" screw terminal (under the dashboard,
fig. 1 1, page 2)
– Connect the brown cable to an available earth point
Suitable for installing in the following vehicles
13