Dometic WAECO MagicTouch MT200 AU4 Indicaciones Para El Montaje Específicas página 15

_MT200_AU4.book Seite 15 Montag, 19. April 2010 7:26 19
MagicTouch MT200 AU4
Audi Cabrio
The connection to the power supply is made at the central locking control device. The
central locking control device is located behind the arm rest of the rear seat.
➤ Disconnect the ring sleeves from the following cables of the radio remote
control:
– Red cable
– Orange cable
– Brown cable
Audi Cabrio to 96
➤
Connect the following cables of the radio remote control using piercing connec-
tors (fig. 4, page 3):
– Connect the red cable to the red/yellow original cable from the white, 16-pin
plug
– Connect the orange cable to the black/red original cable from the white,
16-pin plug
– Connect the brown cable to the brown original cable from the white, 16-pin
plug
Audi Cabrio from 96
➤
Connect the following cables of the radio remote control using piercing connec-
tors (fig. 4, page 3):
– Connect the red cable to the red original cable from the black, 16-pin plug
– Connect the orange cable to the white/yellow original cable from the black,
16-pin plug
– Connect the brown cable to the brown original cable from the black, 16-pin
plug
Seat Arosa and VW Lupo
The connection to the power supply is made on the driver's side at the fuse box
underneath the dashboard.
➤
Connect the red cable of the radio remote control to the "+30" screw terminal
(underneath the dashboard, fig. 5 1, page 3).
➤ Disconnect the ring sleeve from the orange cable of the radio remote control.
➤
Use a piercing connector to connect the orange cable of the radio remote control
to the black/yellow original cable (sw/ge) (fig. 6 1, page 3), which is located
underneath the steering column and which leads to the ignition socket.
➤
Connect the brown cable of the radio remote control to an available earth point.
Installing and connecting the MT200
15