_MT200_AU4.book Seite 19 Montag, 19. April 2010 7:26 19
MagicTouch MT200 AU4
Seat Arosa and VW Lupo
Activation of the central locking is performed on the A pillar in the footwell behind the
bonnet opener.
Activation of the indicators is performed in the cable strand underneath or on the right
side of the steering column.
➤
Connect the following cables of the radio remote control using piercing connec-
tors (fig. a 1, page 5):
– Connect the grey cable to the grey/yellow original cable which is located on
pin 10 of the 10-pin, brown plug
– Connect the blue/red cable to the blue/purple original cable which is located
on pin 9 of the 10-pin, brown plug
➤
Connect the following cables of the radio remote control using piercing connec-
tors (fig. 6, page 3):
– Connect the black/green cable to the black/green original cable (sw/gn)
which is underneath the steering column and which leads to the indicator
switch.
– Connect the black/white cable to the black/white original cable (sw/ws) which
is underneath the steering column and which leads to the indicator switch.
2.3
Completing installation
➤
Reattach the strap on the negative terminal of the vehicle battery again.
➤
Test the radio remote control to see if it works correctly.
➤
Fasten the control device in place using the fastening material supplied.
➤
Remount the panels and covers removed.
Installing and connecting the MT200
19