Before You Start; What's In The Box; Loading The Batteries In The Remote Control; Using The Remote Control - Pioneer X-CM32BT-K Manual De Instrucciones

Ocultar thumbs Ver también para X-CM32BT-K:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Before you start

Chapter 1:
Before you start

What's in the box

Please confirm that the following accessories are in the box
when you open it.

• Remote Control

• AAA batteries (R03) x 2
• Power cord
• Speaker wire x 2
• AM antenna cable
• FM wire antenna
• Non-skid pads x 8
• iPhone/iPad stand
• Operating instructions (this document)
Loading the batteries in the
remote control
1
Open the rear lid and load the batteries as
illustrated below.
2
Close the rear lid.
CAUTION
• Do not use any batteries other than the ones specified.
Also, do not use a new battery together with an old one.
• When inserting the batteries, make sure not to damage
the springs on the battery's  terminals. This can cause
batteries to leak or over heat.
• When loading the batteries into the remote control, set
them in the proper direction, as indicated by the polarity
marks ( and ).
• Do not heat batteries, disassemble them, or throw them
into flames or water.
• Batteries may have different voltages, even if they are the
same size and shape. Do not use different types of
batteries together.
• To prevent leakage of battery fluid, remove the batteries
if you do not plan to use the remote control for a long
period of time (1 month or more). If the fluid should leak,
wipe it carefully off the inside of the case, then insert
new batteries. If a battery should leak and the fluid
should get on your skin, flush it off with large quantities
of water.
• When disposing of used batteries, please comply with
governmental regulations or environmental public
institution's rules that apply in your country/area.
WARNING
• Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a
heater. This can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the life or
performance of batteries.

Using the remote control

The remote has a range of about 7 m (23 ft.) at an angle of
about 30º from the remote sensor.
30°
30°
7 m (23 ft.)
Keep in mind the following when using the remote control:
• Make sure that there are no obstacles between the
remote and the remote sensor on the unit.
• Remote operation may become unreliable if strong
sunlight or fluorescent light is shining on the unit's
remote sensor.
• Remote controllers for different devices can interfere
with each other. Avoid using remotes for other
equipment located close to this unit.
• Replace the batteries when you notice a fall off in the
operating range of the remote.
01
7
En

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

X-cm32bt-w

Tabla de contenido