English - Braun 5 Serie Manual Del Usuario

English

All manuals and user guides at all-guides.com
Our products are designed to meet the
highest standards of quality, functionality
and design. We hope you enjoy your new
Braun Shaver.
Warning
Your shaving system is provided with a
special cord set, which has an integrated
Safety Extra Low Voltage power supply.
Do not exchange or tamper with any part
of it, otherwise there is risk of an electric
shock.
Do not shave with a damaged foil or cord.
This appliance is not intended for use
by children or persons with reduced
physical, sensory or mental capabilities,
unless they are given supervision by a
person responsible for their safety. In
general, we recommend that you keep
the appliance out of reach of children.
Children should be supervised to ensure
that they do not play with the appliance.
To prevent the cleaning fluid from leaking,
ensure that the Clean&Renew station is
placed on a flat surface. When a cleaning
cartridge is installed, do not tip, move
suddenly or transport the station in any
way as cleaning fluid might spill out of
the cartridge. Do not place the station
inside a mirror cabinet, nor place it on
a polished or lacquered surface.
The cleaning cartridge contains a highly
flammable liquid so keep it away from
sources of ignition. Do not expose to
direct sunlight and cigarette smoking nor
store it over a radiator.
Do not refill the cartridge and use only
original Braun refill cartridges.
Description
Clean&Renew station
1 Level indicator
2 Lift button for cartridge exchange
3 Station-to-shaver contacts
4 Start button
10
5 Station power socket
6 Cleaning cartridge
Shaver
7 Shaver foil
8 Cutter block
9 Foil release buttons
10 Long hair trimmer
11 Comfort setting switch «sensitive»
12 Shaver-to-station contacts
13 On/off switch
14 Shaver display
15 Cleaning light (yellow)
16 Replacement light for shaving parts
17 Shaver power socket
18 Special cord set
19 Etui
A Before shaving
Prior to first use, you have to connect the
shaver to an electrical outlet using the
special cord set (18) or alternatively,
proceed as follows:
Installing the Clean&Renew station
• Using the special cord set (18), connect
the station power socket (5) to an
electrical outlet.
• Press the lift button (2) to open the
housing.
• Hold the cleaning cartridge (6) down on
a flat, stable surface (e.g. table).
• Carefully remove the lid from the
cartridge.
• Slide the cartridge into the base of the
station as far as it will go.
• Slowly close the housing by pushing it
down until it locks.
Charging the shaver in the
Clean&Renew station
Insert the shaver head down into the
cleaning station. (The contacts (12) on
the back of the shaver will align with the
contacts (3) in the cleaning station).
If required, the Clean&Renew station will
start charging the shaver now.