Braun 5 Serie Manual Del Usuario página 11

All manuals and user guides at all-guides.com
A full charge provides up to 45 minutes
of cordless shaving time. This may vary
according to your beard growth.
The best environmental temperature for
charging is between 5 °C to 35 °C. Do not
expose the shaver to temperatures higher
than 50 °C for extended periods of time.
Shaver display
The shaver display (14) shows the charge
status of the battery. During charging or
when using the shaver, the respective
battery segment will blink (green). When
fully charged, all segments will light up
for approximately one hour, provided the
shaver sits in the C&R station.
The red low-charge light flashes when the
battery is running low.
You should be able to finish your shave.
B Shaving
Press the on/off switch (13) to operate the
shaver.
Comfort setting switch «sensitive»
Setting the shaver head according to your
comfort needs.
The «sensitive» switch (11) provides three
options for comfort setting:
1
« + » :
The shaver head is in full swing, freely
follows the contours of your skin to
provide more comfort.
2
middle position:
The shaver head is semi-fixed for more
control.
3
« – » :
The shaver head is fixed for full control
and precise handling in hard to reach
areas.
Long hair trimmer
To trim sideburns, moustache or beard,
slide the long hair trimmer (10) upwards.
Tips for the perfect shave
For best results, Braun recommends
you follow 3 simple steps:
1. Always shave before washing your
face.
2. At all times, hold the shaver at right
angles (90°) to your skin.
3. Stretch your skin and shave against
the direction of your beard growth.
Shaving with the cord
If the shaver has run out of power
(discharged), you may also shave with the
shaver connected to an electrical outlet
via the special cord set.
Cleaning
For best shaving results, we recommend
cleaning the shaver in the station after
each shave (see «Automatic cleaning»).
All charging and cleaning needs are then
automatically taken care of.
Cleaning indicator
Clean your shaver in the Clean&Renew
station at the latest when the yellow
cleaning light (15) shines constantly after
shaving. If this is not done, the cleaning
light will go off after some time and the
counter will be reset.
C Automatic cleaning
The Clean&Renew has been developed
for cleaning, charging and storing your
shaver. After each shave, return the
shaver to the Clean&Renew station and
proceed as follows:
• Insert the shaver head down into the
cleaning station.
• Push down the start button (4).
The cleaning process will start (approx.
5 minutes cleaning, 4 hours drying).
• Do not interrupt the cleaning process,
as it leaves the shaver wet and not
fit for use. If interruption is needed
nonetheless, press the start button (4).
11