Braun 5 Serie Manual Del Usuario página 12

All manuals and user guides at all-guides.com
• When cleaning is finished, the yellow
cleaning light will go off and the shaver
is ready for use.
• A cleaning cartridge should be sufficient
for about 30 cleaning cycles. When
the level indicator (1) has reached the
« » mark, the remaining fluid in the
cartridge is sufficient for about 5 more
cycles. Then the cartridge should be
replaced, when used daily approx.
every 4 weeks.
• The hygienic cleaning cartridge
contains alcohol, which once opened
will naturally evaporate slowly into the
surrounding air. Each cartridge, if not
daily used, should be replaced after
approximately 8 weeks.
• The cleaning cartridge also contains
lubricates, which may leave residual
marks on the shaver head after clean-
ing. However, these marks can be re-
moved easily by wiping gently with a
cloth or soft tissue paper.
Cleaning the housing
From time to time clean the housing of
the shaver and the Clean&Renew station
with a damp cloth, especially inside the
cleaning chamber where the shaver rests.
Replacing the cleaning cartridge
After having pressed the lift button (2) to
open the housing, wait for a few seconds
before removing the used cartridge to
avoid any dripping.
Before discarding the used cartridge,
make sure to close the openings using
the lid of the new cartridge, since the
used cartridge will contain contaminated
cleaning solution.
D Manual cleaning
The shaver head is suitable for
cleaning under running tap water.
Warning: Detach the shaver from
the power supply before cleaning
the shaver head in water.
12
Rinsing the shaver head under running
water is an alternative way to keep the
shaver clean, especially when traveling:
• Switch the shaver on (cordless) and
rinse the shaver head under hot running
water. You may use liquid soap without
abrasive substances. Rinse off all foam
and let the shaver run for a few more
seconds.
• Next, switch off the shaver, press the
foil release buttons (9) to remove the
shaver foil (7) and cutter block (8).
Then leave the disassembled shaving
parts to dry.
• If you regularly clean the shaver under
water, then once a week apply a drop
of light machine oil onto the long hair
trimmer (10) and shaver foil (7).
The following quick cleaning is another
alternative cleaning method:
• Press the foil release buttons (9) to lift
the shaver foil (do not remove the foil
completely). Switch on the shaver for
approx. 5–10 seconds so that the
shaved stubbles can fall out.
• Switch off the shaver. Remove the
shaver foil and tap it out on a flat
surface. Using a brush, clean the inner
area of the shaver head. However, do
not clean the shaver foil nor the cutter
block with the brush as this will damage
them.
Keeping your shaver in top
shape
Replacing the foil and cutter block /
reset
To maintain 100% shaving performance,
replace the shaver foil (7) and cutter block
(8), when the replacement symbol (16)
lights up (after about 18 months) or when
cassette is worn.
The replacement symbol will remind you
during the next 7 shaves to replace the
shaver foil and cutter block. Then the
shaver will automatically reset the display.