Installation Instructions; Positioning; Door Space Requirements; Leveling The Unit - Candy CCTOS 502WHN Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 96

INSTALLATION INSTRUCTIONS

Before use, remove all packing materials, including bottom cushions, foam pads and tapes inside of
the refrigerator; tear off the protective film on the doors and the refrigerator body

Positioning

1.
Avoid placing the appliance near cookers, radiators or in direct sunlight.
2.
Install the appliance in a well-ventilated indoor place
3.
The appliance should be located on a smooth surface.
4.
It is forbidden to use the refrigerator outdoors.
5.
Do not locate the freezer in moisty or watery space to avoid the metal parts rusty. Do not spray
water to the freezer, to avoid reduction of insulating effect and current leakage.
6.
The top space of the refrigerator shall be greater than 30cm, the back space from the wall shall
be more than 10 cm to facilitate heat dissipation

Door Space Requirements

The unit's door must be able to open fully as shown. Spare enough space for
convenient opening of the doors and drawers.
W×D≥890×1005mm

Leveling the Unit

To do this, adjust the two leveling feet at the front of the unit. If the unit is not
level, the door and magnetic seal alignments will not be covered properly.
Make sure that the foot touches the ground before use.
Adjusting procedures:
a.
Turn the feet clockwise to raise the refrigerator;
b.
Turn the feet counterclockwise to lower the refrigerator;
c.
Adjust the right and left feet based on the procedures above to a horizontal level

Door reversibility

1.
Power off the refrigerator and remove all objects from the door tray
2.
Fix the door with tape
3.
Unscrew the top cover screws and remove the top cover
17

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido